标题: 更改上电检测母板eeprom [打印本页] 作者: anycrying 时间: 2019-1-3 16:50 标题: 更改上电检测母板eeprom 系统上电时,核心板要检测母板上的eeprom,在0x50上的。能不能修改这个功能?
U-Boot SPL 2014.07-g10e4fe2 (May 18 2018 - 11:01:09)
Could not probe the EEPROM at 0x50
Could not get board ID.
U-Boot 2014.07-g10e4fe2 (May 18 2018 - 11:01:09)
I2C: ready
DRAM: 512 MiB
NAND: 512 MiB
MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1
Card did not respond to voltage select!
** Bad device mmc 0 **
Using default environment
作者: 梁淑怡-Tronlong 时间: 2019-1-3 18:15
您好,
TI提供的U-Boot就是会自动检测EEPROM,如果您想修改此功能,需要您自行修改U-Boot源码,我司未进行过此类操作。您可以在U-Boot源码里搜索“Could not probe the EEPROM at 0x50”找到对应的行将它注释掉。作者: anycrying 时间: 2019-1-6 21:42 本帖最后由 anycrying 于 2019-1-6 21:48 编辑